Disculpe, en este sitio no están permitidas las opciones del click derecho. Lacau.
logo

Bananzia in Practice: A Street-Level Heat Survey Before the Heat Pump

On a row of 1930s terraced houses, the first heat-pump quote often arrives before anyone has measured wall areas, checked radiator sizes or compared loft insulation. The result is a high quote built on weak assumptions. The bananzia method starts with a simple question: what does this street need before any boiler is replaced? That shift from individual purchase to shared survey changes the sequence of work, and it gives residents a common record instead of a stack of unrelated quotes.

Map heat demand by house type

Houses built in the same era and style usually share heat-loss patterns, so a street survey can group them into useful archetypes. A mid-terrace with solid walls loses heat differently from an end-terrace with an exposed gable, and a later extension can change the picture again. The survey should record floor area, wall construction, glazing, loft depth and radiator output; in a 1930s solid-brick terrace, it should also flag draught paths at skirting boards and joist ends. Recording these details once gives installers a reliable starting point and reduces the risk of oversizing a heat pump for the whole row.

Check the low-temperature system

Most heat pumps run efficiently at flow temperatures around 45°C or lower, while many gas radiators were sized for 70°C or more. A radiator that is too small forces a higher flow temperature, which lowers heat-pump efficiency; a 600mm by 1200mm panel may need to become a 600mm by 1600mm panel or a fan-assisted unit. In one three-bedroom mid-terrace, enlarging the living-room radiator and adding a low-temperature-ready hot-water cylinder allowed the system to run at 45°C without sacrificing comfort. The takeaway is practical: radiator surface and cylinder size belong in the survey, not in a late-stage surprise.

Sequence fabric, controls and equipment

Fabric improvements should come before equipment sizing because they change the load the heat pump must meet. Loft insulation from 100mm to 270mm is a common first measure, and draught-proofing around windows and doors is low-cost; cavity or solid-wall insulation can follow where the construction allows. Smart controls can then shift operation to cheaper or cleaner electricity, but they cannot compensate for a poorly sealed house. When these steps are recorded first, the result is a smaller heat pump, a more accurate quote and lower running costs over the life of the system.

Use the survey as a shared record

A single street record prevents repeated surveys and helps competing installers compare like with like. Photos of pipework, radiator dimensions, EPC data and insulation notes create a common evidence base that residents can reuse when they request quotes. The record should also include primary pipe diameters and cylinder location, because heat pumps need adequate pipework and space for a larger hot-water cylinder. The result is faster quoting, fewer site visits and a clearer route from a cold terraced house to a low-carbon heating system.

Comments are closed.

rafaellacau.com

Verify you are human by completing the action below.

This website uses a Cloudflare to protect against malicious bots. This page will remain displayed while the website verifies that you are not a bot.

A security check is in progress. Please wait